I. Description: This product is the use of thermal insulation, fire-resistant inorganic mineral lightweight aggregate outstanding performance with a variety of additives such as cement-based composite made of insulation material, a convenient construction, strong adhesion and energy saving features. Second, the product uses: This product is suitable for interior and exterior insulation, excellent fire performance, high security. Third, the product performance: dry apparent density (kg/m3) ≤ 350 Compressive strength (MPa) ≥ 0.50 Tensile strength (MPa) ≥ 0.10 Thermal conductivity (W / m · k) ≤ 0.070 Linear shrinkage (%) ≤ 0.25 softening coefficient ≥ 0.60 Fourth, the construction process: 1. Cleaning the surface floating dust, pop insulation thickness control lines. 2 and water is added (generally comprise material weight (85 to 95) about%) thermal mixing mortar 2 to 3 minutes, 5 minutes and then allowed to stand for 30 seconds can be used. 3 to find the rules for ash cake for red bars. 4 2 to 3 times to complete insulation plaster. 5. Rub flat, calendering, wiping crack protective layer. 6 clean up the site. Fifth, packaging and storage, transportation: 1 Packaging: Powder 40kg ± 1kg / bag; lightweight aggregate 80L ± 5 / bag. 4 packets of powder; 12 pack light material 2, this product is an inorganic material, non-toxic, tasteless, non-radioactive. 3, the product should be stored in a dry room, forbidden rain, moisture. 4, from the date of manufacture of the product, the shelf life of six months. VI Notes: 1, each slurry shall allocate too much, you should use with the mix with, the use shall not be mixed with other cement, gravel, etc.; 2, the product shall not be lower than the general construction of the ambient temperature 5 ℃. ; 3, to ensure that the material ratio, after unpacking the product should use the whole bag of water mixing. Seven, the implementation of standards: JGJ253-2011 "inorganic lightweight aggregate technical regulations mortar insulation system"